Thank You for
purchasing the DOWN UNDER Wonder®SHOWER.
Before you
start to install your Wonder Shower, please read these
“INSTALLATION INSTRUCTIONS” (“10 minute installation,
including a 5 minute coffee break!”)
Remove old
showerhead and arm, using a pipe wrench to loosen. Turn arm
counter-clockwise until removed. Wrap threads on one end of
male nipple with 4 to 6 wraps of Teflon tape (clockwise).
Start that end of male nipple into female nipple (in wall),
hand tighten, then tighten 1-2 turns (clockwise) with pipe
wrench or slip wrench. Insert fiber washers (2) into hex
inlet nut of Wonder Shower, start the hex inlet nut on the
end of nipple sticking out of the wall.
Holding the
Wonder Shower by the arm, turn hex inlet nut clockwise until
hand tight. Carefully adjust crescent wrench to fit snuggly
on hex inlet nut, tighten ½ - ¾ turn, until tight. Swing
shower up or down and adjust wing nuts to hold in place.
Turn the water on to make sure connection is watertight.
Most Importantly, take your time and enjoy the plumbing
exercise. You will feel even better when “Standing Under the
Wonder” after installing it yourself.
Please feel
free to call the Wonder HELP LINE 1-800-595-0385 anytime if
you have questions about your Wonder®Shower, it’s
installation and use or to tell us how much more you enjoy
taking a shower now that you are the proud owner of a Wonder
Shower!
top
Installing On
Existing Shower Arm
If you prefer,
you can install your Wonder®Shower on the existing shower
arm where the old showerhead was mounted. Remove old
showerhead, clean the threads on shower arm. Install
Wonder®Shower by first inserting fiber washers (2) into hex
inlet nut then start the hex inlet nut onto shower arm,
holding extension arm in one hand turn hex Inlet clockwise
until hand tight. Carefully adjust crescent wrench to fit
snuggly on hex inlet nut, tighten ¼ - ½ turn, until tight.
Fiber washers will seat after first shower eliminating any
minor leaks you may experience immediately after
installation. Swing shower up or down and adjust wing nuts
to hold in place.
Check
installation for leaks by turning the shower on, any leaks
will require minor tightening or adjustment. Be creative
when adjusting your Wonder®Shower as it can be adjusted to
many different positions, one or more of which is perfect
for you.
top
Tools You Will Need
